All Categories  
 

All Categories

 

Click on a category to drill down.

Flowmeters for Liquids and Gases

Liquid Flowmeters and Gas Flowmeters


The Flo-Gage is a direct reading liquid flowmeter and gas flowmeter with a large easy to read dial calibrated in engineering units (GPM, SCFM, LPM, etc.). The Flo-Gage is suitable for measuring water, oil, and most low viscosity liquids as well as compressed air, oxygen, carbon dioxide, nitrogen and many other non-toxic compressed gases. Saturated steam can also be measured up to 120 psig max. The flowmeter is self contained and complete. Available in threaded and flanged connection.
Transmitters for Liquids and Gases

Flow Transmitters for Liquids and Gases


The Flo-Gage can be fitted with a 4 wire transmitter to provide a 4-20mA (linear) output signal (Option W), 0-1000 Hz frequency outputs for remote totalization (Option Y), high/low relays for signaling flow conditions (Option X) or Option Z combines option W, X and Y in one unit. Our 2 wire loop powered 4-20mA (square root) output signal (Option W2 or W3) with either an indicating or non-indicating transmitter. Our flow transmitters for liquids and gases are available in threaded and flanged connection. 24Vdc power supply required (PS-24).
Flow Switches Liquids and Gases

Flow Switches Liquids and Gases


Our General Purpose flow switches (liquid and gas) reed switches (Option 1S2 or 2S2) are an economical solution for equipment protection and automation for critical processes in a variety of industrial applications. They can be ordered for use in a hazardous location enviroment (Option IS or Option IS-LED). LED’s provide viewing at a glance and easy field calibration. These switches are CSA and ATEX approved and operate in the most demanding environments. Each switch is independently adjustable for ease in configuring a safety interlock or control circuit. Available in threaded and flanged connection.
Digital Display Flow Meters for Liquids - RW3

Digital Display Flow Meters for Liquids and Gases


The New digital display flow meter is a 2 wire loop powered 4-20mA DC indicator that displays a flow rate and total. On-screen engineering units are easily configured. Password protection and 16 bit A/D resolution. A New built in wet/wet differential pressure sensor is protected by an isolated stainless steel diaphragm and provides a 4-20mA DC signal to the display. The enclosure is IP67 / NEMA 4X rated which further enhances this models capability. Available in threaded or flanged connection and bronze or stainless steel construction..